Need a place to display all those Amiibo lying around your house? This 2 part print will allow you to place you Amiibo Buddies on your computer monitor! The two pieces fit together tightly so there is no need for glue! will take a little strength to get the pieces together but this was intentional, making the part strong!
I printed on Tevo Michelangelo
Sliced using Cura 3.2.1
Supports Touching build plate.
0.2 layer height
220 nozzle temp for initial layer
200 nozzle temp every layer after.
20 mm/s initial layer, follow by 60 mm/s for every layer after.