Angel Tea Light
Angel Tea Light
3D
Published 2017-03-27T18:39:34+00:00
An angel tea light, for my angel of course! Also planning on using these for stocking stuffers at Christmas.
Two pieces to print, and a tea light to purchase (I used the "flickering" effect tea light).
Video of prototype here: https://www.youtube.com/watch?v=8kCd0VV2uk0.
Designed using Sketchup Make 2016, sliced with Cura, and printed in PLA on an Ultimaker 2 Extended.
For speed of prototyping, I printed the prototypes at .2mm.
Parts I Purchased:
1) Flickering candle effect tea light (box stores, craft stores, amazon).
Printing:
Print 1 each of the two parts.
Assembly:
Prior to assembly, test fit and trim, file, sand, etc. both parts as necessary for tight fit . Depending on the colors you chose and your printer settings, more or less trimming, filing and/or sanding will be required.
1) After clean up, press "Angel Tea Light Small.stl" into "Angel Tea Light Small Base.stl".
2) Test fit your tea lamp in "Angel Tea Light Small Base.stl". The base opening for the tea lamp is 40mm in diameter which was chosen after a few different brands of tea lights were tried. Some brands fits tight, others fit loose. If your tea lamp is loose, wrap tape around the circumference of the tea lamp base until a tight fit is attained.
Hope you like it!
| 发表的日期 | 27/03/2017 |
| 打印工艺 | FDM |
Printed it at 100 % and 130 %.