Apple Logo Flip-top Box
- 同人作品>
- LOGO打印 |
- 家居产品>
- 起居室>
- Storage and boxes
Apple Logo Flip-top Box
3D
Published 2017-03-21T13:24:28+00:00
The 'Apple Flip-top Box' is a must print for every Apple fan...
This is a one piece print of an Apple logo shaped container for small things. The top / lid of the box is hinged so it flips backwards to open.
At standard scale the internal storage area measures approx. 54mm (W) x 51mm (H) x 41mm (D).. It can be scaled up but scaling down is not recommended as it will reduce clearances so moving parts may fuse together. Even at standard scale a small amount of 'wriggling' may be required to break the top / bottom free from each other so they move freely.
This is a straight forward PLA print (ABS may be a challenge due to the extreme angles used in a few areas). It should be a straight forward print for machines with a filament fan and good bridging capability.
Wall thicknesses have been kept thin to minimize filament consumption and print time. Raft is optional. Do not use any automated support as it could fuse the hinge and fill the internal storage area. To ensure it is strong use a minimum of 25% infill.
This is a very cool little storage design. Use it your self or as a gift for any Apple fan.
Please refer to the instructions and images for additional information.
Note: If you like this check out the rest of my practical and fun designs.... and post images of your prints! .
Straight forward print. So not use any automated support. Should print well in PLA on machines with a filament fan (as this helps deal with the extreme angles applied).
Ready to use straight away...
As the clearances applied are quite tight you may need to gently free the two halves (Upper / Lower). A few gentle wriggles is all that should be required. If more force is necessary try gently running your finger nail or a craft knife around the seam between the halves (Note: In the prints completed so far on my Replicator 2 and 5th Gen Replicator the halves could be easily freed by hand with minimal effort).
| 发表的日期 | 21/03/2017 |
| 打印工艺 | FDM |
