Bebop 2 Sky Controller mount
Bebop 2 Sky Controller mount
3D
Published 2017-02-03T13:12:21+00:00
This is an adapter that allows the Bebop 2 drone to be stored and carried on the Sky Controller 2. The adapter simply locks into the phone holder, then the clips hold the main cross frame. There is a center raised section to assist in centering the drone on the mount, and you can clip a lanyard onto the metal ring on the phone adapter to carry by a strap. The locking action to the drone is very secure and may require the drone and adapter be removed from the controller prior to removing the adapter from the drone bottom with a slight bending of the adapter, but not much.
Printed on a daVinci 1.1PLus using ROBO 3D Black ABS. Use of supports is recommended since the center frame locator has about 1/8 inch gap between it and the build platform but because it is such a small area a good printer may not need them at all, otherwise no other supports are needed or generated. Printed using .4mm nozzle, .2 layer height, 50% octogon infill with thick shells. With extrusion set at slow took approx 4 hrs 27 min.
| 发表的日期 | 03/02/2017 |
| 让时间去下载 | - 267 分钟 |
| 材料数量 | 13.470m |
| 尺寸大小 | 21.59 x 125.2 x 45.75 |
| 打印工艺 | FDM |
