Can Holder V2 #Tinkerfun
Can Holder V2 #Tinkerfun
Published 2018-06-04T19:12:18+00:00
Similarly to the first version of my Cup Holder, this one is designed for the 330ml can. However, it can be used for other cans too (not larger but smaller) and some bottles!
This design was made to keep your beverages a bit colder for a bit longer :D
V2 is new and improved as it is fully 3D printable without supports!!!
Yay for faster prints and less plastic!
Happy Summer!
This object was made in Tinkercad. https://www.tinkercad.com/things/h4PDqChYSUz
I recommend printing with ABS or PETG as it may need to endure hot temperatures when being transported to a picnic location.
This print can be printed on a 125mm x 125mm print bed (such as the one the Snapmaker has) if rotated at a 45 degree angle. The handle is 4 mm shorter than the previous one leaving more room for error with placement and again, more plastic saved!
Use maybe 10-25% infill to reduce the amount of heat that will be transferred from your hand into the can.
The print time is approx 5h 40 mins.
发表的日期 | 04/06/2018 |
支持自定义 | YES |