Elveet. Kinetic Charger Powerbank case
Elveet. Kinetic Charger Powerbank case
3D
Published 2018-05-02T16:46:49+00:00
My new kinetic charger power bank.
Once I was on a trip and I had a problem with recharging my gadgets. I traveled for a long time on the bus, did not have the opportunity to charge my phone and knew that I would soon be without communication.
So came the idea to create a kinetic charger, which will not depend on the power outlet.
If you need to recharge your gadget on a trip, hike, on the beach or in transport, then Elveet will help you. You can just shake Elveet or put it in your bag (backpack) and go to work (go hiking, to the beach, to the mountains, etc.). The device is charging when you are moving.
The whole project is created in Fusion 360.
Instructions here:
https://www.instructables.com/id/Elveet-Kinetic-Charger-Poverbank/
https://www.youtube.com/watch?v=YtN3dH8syvo
Magnets: https://www.indigoinstruments.com/magnets/rare_earth/
Printer:
Anet A8
| 发表的日期 | 02/05/2018 |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |