Expandable Vertical Toolbox
Expandable Vertical Toolbox
3D
Published 2015-06-19T02:24:59+00:00
I got several m10 threaded rod lying around so I just got an idea making these. Based on another idea, but the hardware for this are easily accessible without the need of exotic materials such as 3mm smooth rods and 3mm neodymium magnets that can be hard to find on your local stores
This vertical toolbox also have latch feature that will clip that partition on to the threaded rod
The original design uses M10 threaded rod What you need: 1. 2 x M10 threaded rod 2. 4 x M10 nut 3. 1 x handle (printed) 4. 1 x base (printed) Each handle and base object has 2 version, Handle: - Closed nut, still need 4 nut to fix it to the threaded rod, the other 2 are inserted from below the handle bars, you have to spin the threaded rod instead of the nut - Open nut easy fixing but both nut have to be leveled, then add another from top to prevent the handle slipping from the threaded rod Base: - Basically short and tall platforms to suit your need Partitions: - Each one of them has 3 different height, 10, 25 and 50mm (inner height), each height categories has smaller partition from 1 (empty) up until 8 and there are also a rounded version for every single one of them - The file name has 3-4 characters eg 508r.stl would mean that it is 50mm height with 8 compartment and rounded edge - 50mm height probably not recommended because it is so tall and the clip are not so flexible thus making it hard to be opened and closed and recommended to be smeared with acetone (for abs) to ensure there are no layer breaking up due to frequent open/close (my case here it has split apart on lower layer due to inflexibility)
| 发表的日期 | 19/06/2015 |
| 让时间去下载 | 300 - 分钟 |
| 复杂程度 | 中级 |