Fiat Key shell replacement
Fiat Key shell replacement
3D
Published 2014-10-25T09:21:33+00:00
This is a replacement shell for Fiat car keys. It's not a perfect fit. But it's good enough for me. Especially since I wanted my car keys to be in a glow-in-the-dark blue. I bought my car back in 2010, so I don't know if later (or earlier) key shells will be a compatible fit. So apologies if that's the case. I also haven't done any optimisations for support structure. The lower half measures : 3.25 x 6.90 x 1.30 cm and the upper half measures : 3.25 x 6.90 x 0.95cm I printed this on my FlashForge Dual Creator at a resolution of 0.15mm, with an overall print time of about 1hr 40min. Note for printing : I turned off the "Cool" feature in ReplicatorG so that the printer doesn't slow down on the last few layers. This prevents a large amount of blobbing. But some trimming will still be required.
Print at 0.2 mm layer height, with 50 % infill. This uses 6.7 g of filament and takes 31 minutes .
| 发表的日期 | 25/10/2014 |
| 让时间去下载 | 31 - 31 分钟 |
| 材料数量 | 6.7 g |
| 尺寸大小 | 58 x 58 x 13 |
| 复杂程度 | 容易 |