Filament Guide, Filament Cleaner and Cable Clip 3-in-1 for Creality CR 10, Ender 3 and Ender 2
24,903
views
2,992
downloads
41
collections
5 comments
Loading comments... 
Filament Guide, Filament Cleaner and Cable Clip 3-in-1 for Creality CR 10, Ender 3 and Ender 2
3D
Published 2018-08-20T17:54:24+00:00
827
5
Add to Collection
Description
3-in-1 filament guide, filament cleaner and hotend cable clip for Creality Ender 3, Ender 2 and CR10 variants.
Guide is fastened with the existing 2xM3 screws.
Simply chop up a kitchen sponge and put that in the back cavity for the filament cleaner.
Print on front end standing upright as shown in the photo with supports enabled.
Technical Information
| 发表的日期 | 20/08/2018 |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
More Information
Object Parts
Works well! Printed it out and installed it thinking that it might be tight around the Z but it fitted perfectly. Unfortunately I had to remove the end of the extension as the support was stuck. That was probably my fault for using an automatic splicer. Wire holding works well too, and despite losing the bolt and searching for an hour, it was successful.