Grand Cherokee Switch panel
Grand Cherokee Switch panel
3D
Published 2018-02-13T18:28:22+00:00
Switch panel that replaces the factory cubby on left side of dash. Fits five 3/4 inch switches made to fit Hella switch #H61923001. The cheap push in rocker switches on Amazon will fit but don't like to stay in, (well at least the ones i have) The part is 1/8 thick. Should fit Jeep Grand Cherokee Wk 2008-2010.
Possibly Jeep Commander of the same years. (If someone tries let me know.)
Actual part dimensions 144mm long, 58mm tall, 3mm thick, holes 20mm.
Not perfect but works good for now.
The tabs are a tight fit be careful removing it after test fitting, once the switches are in you will more than likely have to push it out from the back.
---The square hole one has NOT been tested I was asked to add it. Hole size is 25mm x 48mm---
For me 20% infill .2 layer hight. I printed it with 3 walls, Needs a brim
| 发表的日期 | 13/02/2018 |
| 让时间去下载 | 2 - 55 分钟 |
| 材料数量 | 38 grams |
| 尺寸大小 | 144mmx58mmx3mm |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |