Hand
Hand
Published 2015-12-17T14:39:44+00:00
This prosthesis has been designed to help those people with missing fingers.
It has been modelled keeping in mind the following principles:
-Keep the number of printed parts as low as possible
-Keep the assembly process as simple as possible
-Use the least possible amount of non-printable parts. The bolts and nuts in the joints have been replaced by bits of 1.75mm filament.
-Leave openings in the model to allow the hand to transpire
-Allow a higher degree of freedom in the wrist
The fingers flex when they are pulled by strings, such as fishing line, and extend automatically with the help of elastic cord.
A fabric strap with velcro is needed to secure the prosthesis to the arm.
The model is open-source, and thus can be studied and modified to improve its performance.
Author: http://www.soniaverdu.es/
Print Settings
Rafts: Doesn't Matter
Supports: Doesn't Matter
Resolution: 0.2 mm
Infill: 10%
Notes:
For greater resistance: Shell thinkness(mm) 1.2
Post-Printing
You can use tape boxer, it is cotton. Then you can add velcro where you need it.
发表的日期 | 17/12/2015 |