Igloo mono amplifier
Igloo mono amplifier
3D
Published 2015-09-23T10:59:31+00:00
This case for the Kitronic Mono Amplifier is inspired by an igloo. Following are the directions for the mounting kit.
1. Take the amplifier and put it resting it on the ring nut (ghiera.stl), then attach the assembly to the dome (calotta.stl) using three 2.9x12.7 mm self-tapping screws.
2. Solder the two amplifier wires to the PCB, then attach the PCB to the basis (base.stl) using the screws and spacers as explained in the mounting instructions.
3. Solder the 9V battery clip to the PCB and put it in place using the rectangular slot on the basis.
4. Pass the jack lead through the small hole on the side of the dome and solder it to the PCB.
5. Attach the basis to the dome using three 2.9x12.7 mm self-tapping screws.
6. Connect the 9V battery and close the battery door.
Print at 0.2mm layer height and 10% infill.
| 发表的日期 | 23/09/2015 |
| 让时间去下载 | 1040 - 1050 分钟 |
| 材料数量 | 128 g |
| 尺寸大小 | Multiple parts |
| 复杂程度 | 中级 |