Printable Bass - Ukulele size!
Printable Bass - Ukulele size!
3D
Published 2019-04-29T15:29:58+00:00
The neck is printable in two parts!
This bass is inspired by the Kala Ubass. It is almost fully printable, except for "serious" mechanics, I wanted to be able to do a real setup with correct intonation, therefor this design uses a Fender style bridge. The strings are ThunderGut standard strings. As seen on pictures there is a hole in the bottom intended to be used with a Fishmann Presys Blend pickup system.
Original mechanics for ubass are prefered for the largest strings. Kalas own are listed below, they are however rather expensive.
https://kalabrand.com/collections/u-bass-parts/products/tuner-u-bass-hipshot-right
You can hear a recording here:
https://soundcloud.com/david-bjorklund-810661191
Parts of this object might change to the better, so please leave your feedback.
| 发表的日期 | 29/04/2019 |
| 打印工艺 | FDM |