Raptor 190 Racing Quadcopter
Raptor 190 Racing Quadcopter
3D
Published 2018-05-23T11:58:00+00:00
Stylish, aggressive lines, fully enclosed electronics for a sleek look and aerodynamic advantage.
The Raptor 190 was designed from the ground up with inspiration from the look and style of the Sigan Drone, Fossils Gravity 250 and Walkera Runner 250 quads. Ultimately I went for a Hawk-like appearance with ventilation holes to simulate feathers.
Print in PETG filament for more resilience and elasticity than ABS or PLA but will remain light and can take a few impacts. It's not as strong as Carbon Fiber but will outperform most other popular 3D printing materials.
Please visit and 'Like' my Facebook page for updates and promotions!
https://www.facebook.com/RaptorFPV/
Full Kit (V10) with Carbon Fiber upper and lower plates as well as all necessary bolts to assemble, antenna tubes, props sets and battery straps available at http://www.RaptorFPV.com
http://www.RaptorDrones.com
https://youtu.be/x0P2ezN-5tY
Recommended Hardware (as seen on my prototype):
-Taranis X9D Plus
-CC3D Atom
-FrSky D4R-II
-ELGAE FPV200 Camera/Transmitter Combo
-Fatshark Dominator V3
-ZTW Spider Series 18A OPTO Multi-Rotor ESC
-Scorpion M-2204-2300KV motors
-Turnigy Graphene 1300mAh 3S
-Suitable Antennas
Want the Carbon Fiber plates and print your own Spacer? Go here for the Version 10 Plates and STL files:
http://raptorfpv.com/h-frames/17-raptor-190-fpv-quadcopter.html
Print 2 Camera Spacers and 1 Antenna Spacer
Supports on the Middle Spacer below the motor mounts.
10x 25mm M3 bolts + lock nuts for the body
4x 12mm M3 bolts + lock nuts to build.
| 发表的日期 | 23/05/2018 |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |