SPINNER | Print-in-place fidget hand spinner
SPINNER | Print-in-place fidget hand spinner
3D
Published 2024-02-16T13:41:57+00:00
SPINNER | Print-in-place fidget hand spinner
Here is a 100% print-in-place fidget spinner to relieve you from all stress, as if staring at your 3d printer wasn't enough. Come on, we've all done it.. "one more layer and after that, I swear, I'm gonna go to bed!"
Tolerance is key, so I made 3 STL files, one for each of the following tolerances:
0.2mm (the one I printed and in the video)
0.25mm
0.3mm.
Pick the ones that'd work best for your printer!
The 0.2mm one works fine but you'll have to wiggle the bearings a little to get them unstuck. And adding a little lubricant helps too (I applied the grease I use for the 3d printer).
Happy printing!
DIMENSIONS | Ø 90mm x H 8 mm
Printing | ~1.5h
3D PRINT SETTINGS
Print-in-place flat on the side, 100% without supports or need for adhesion brim.
Resolution: 0.1~0.15mm / layer
Build adhesion type: None
Supports: None
Infill: gyroid 30~50%
| 发表的日期 | 16/02/2024 |
| 支持自定义 | YES |