Towel hanger clip
Towel hanger clip
Published 2015-02-01T22:14:32+00:00
FACT: Teenagers are unable to hang towels up in the bathroom.
SOLUTION: 3D print yourself this handy simple towel clip,
insert a 20mm diameter ball, the clip has enough 'give' to allow the ball to push in from the side - but it won't fall out (the ball can be bought or 3D printed as well).
Slip the towel up behind the floating ball - ball drops down locking the towel firmly in place. A quick pull on the towel to release it.
Fix to the bathroom door or wall and never again deal with a towel covered bathroom floor!
Print at 0.2mm, high% infill - no support or raft needed for clip.
Ball may require some support if you wish.
Print ball at 100% infill to give it some 'weight' or purchase a 20mm steel ball or marble from any good toy / hardware store.
Scale the Towel clip up or down for other sizes of ball insert.
Enjoy!
Print at 0.2 mm layer height, with 10% infill. This uses 15 g of filament and takes 102 minutes.
发表的日期 | 01/02/2015 |
让时间去下载 | 102 - 112 分钟 |
材料数量 | 15 g |
尺寸大小 | multiple parts |
支持自定义 | YES |