Tumble Dryer door latch Hotpoint
Tumble Dryer door latch Hotpoint
3D
Published 2017-11-20T16:26:03+00:00
This is a replacement part for the door of a Tumble dryer. It is part of the mechanism to close and lock the door.
The reference of the part is C00142619. It can fit models from Ariston, Creda, Hotpoint, Indesit and Proline.
You can check if it fits your model with this link: https://shop.ukwhitegoods.co.uk/c00142619-tumble-dryer-door-latch
This part is subject to stresses so it might break faster than the original part. I recommend printing it in a strong material (like ABS or Polycarbonate).
You can buy it 3D printed on Ebay: https://www.ebay.com/itm/112613961441
This part can be tricky to print, as there is no flat surface. You will need to use support.
You should print the part in ABS or Polycarbonate.
I recommend 100% infill (as the part needs to be as strong as possible) and a layer height of 0.2mm or lower (to increase adhesion between the layers).
| 发表的日期 | 20/11/2017 |
| 尺寸大小 | 29.5mm x 28.1mm x 27mm |
| 打印工艺 | FDM |
| 复杂程度 | 困难 |
