greghess's Print of Werewolf Alpha
Community Print 3D Print of Werewolf Alpha
Published 2021-05-18T02:37:27+00:00
1
0
Description
Fresh off the print and clean, not even cured yet. Printed with Elegoo Mars 2 Pro at 0.025mm layers at 150% with Water Washable Elegoo Beige resin. Setup, supported and sliced in Lychee.
Settings: Elegoo Mars 2 Pro Printer in Lychee, 35 sec bottom layer exposure at 5 layers, 3 sec normal layer exposure, no light-on or off delay, 5mm print up/down, 100mm up/down speed.