pingopango's Print of Articulated Dragon
471
views
1 comments
Loading comments... 
Community Print 3D Print of Articulated Dragon
Published 2022-09-14T15:55:44+00:00
1
1
Printed on: Phrozen Sonic Mini
Material: Resin
Description
Amazing model. Printed directly on the plate on a Phrozen Sonic Mini 8k in resin at 49% scale. Fully articulated from the get-go, everything popped off the standard build plate easily but the feet had to be taken off a bit more carefully with a razor scraper. Made an effort to fine-tune my settings beforehand, and calibrated with Cones of Calibration before printing.
Used an approximate mix of 90% Siraya Tech ABS-like Navy Gray and 10% Siraya Tech Tenacious.
Settings were:
Layer height: .05mm
Bottom layer count: 6
Exposure time: 2.15s
Bottom Exposure time: 25s (IMPORTANT: Allowed enough stick but not so much it broke coming off the plate)
Transition Layers: 5, linear
Rest time before lift: 0s
Rest time after lift: 0s
Rest time after retract: 2s (IMPORTANT: Eliminates elephant foot by reducing the outward squish on the bottom layers, which when not addressed causes smaller articulations to fuse on the bottom.
BOTTOM TOLERANCE COMPENSATION: a: -.3mm; b: -.25mm. This also helps to eliminate the elephants foot significantly. Used digital calipers to measure the elephants foot on a similar print to find these, so they may change for you.
Remaining settings were the recommended settings from Siraya Tech.
Hope this helps someone!