Floating Frame
2,567
views
109
downloads
0 comments
Loading comments... 
Floating Frame
3D
Published 2019-03-11T11:43:16+00:00
36
0
Add to Collection
Description
This is a "floating frame" that is meant to hold anything that is about 1/4" (or 6mm) thick. In my example case I have hung this amazing styelized periodic table done by a local artist and friend of mine, Shane Thelen.
Instructions
Materials Needed:
- 4 x floating-frame-corner printed
- String that fits through the holes in the brackets
Steps:
- Fish the thread through each printed corner bracket
- If you have some thread wax or put tape over the end of the thread that can help if your thread is too soft to easily fish through
- You could also use a bit of wire, fish that through, tie the string to that and pull it through
- Fit each bracket onto a corner of the piece
- Pull the thread tought and tie it off (see back of piece picture)
- (optional) cut the thread so that you have some extra to work with if you should need to adjust it later and tape the excess to the center of the back.
Technical Information
| Date published | 11/03/2019 |
| Support Free | YES |
More Information
Object Parts
