MouseTrap
MouseTrap
Published 2017-03-20T19:17:41+00:00
The 'MouseTrap' is a small but simple device that keeps your wired computer mouse cable neatly coiled at the preferred length for use and/or when being transported.
The design fits common wired Mouse cables (3.25mm) so is a fine/detailed device to print. As some cables may vary slightly, and not all printers print the same, If you print a 'MouseTrap' and find it is either too tight or too loose on your Mouse Cable (it should be a snug press fit into the clips) uniformly scale it up or down slightly until you get a snug fitting result.
This is a small and easy print. On a Replicator 2 /5th Generation Replicator they print in less than 15 minutes including Raft. Using Raft is recommended as it is a small print. The design allows for it to be printed without support (PLA). Please refer to print settings for additional details.
Note: If you like this check out all my other practical and fun designs.... and post images of them in use!
To make these strong for everyday use print them with 2 shells and 75% infill. This works really well on a Replicator 2 and 5th Generation Replicator.
Raft is recommended due to the small size of this print. Does not require support (with PLA).
No clean up required other than Raft removal
Date published | 20/03/2017 |
Technologie | FDM |