PIR sensor faceplate - Bracket for PIR sensor with wire control.
5,660
views
302
downloads
3
collections
0 comments
Loading comments... 
PIR sensor faceplate - Bracket for PIR sensor with wire control.
3D
Published 2018-02-16T15:04:56+00:00
53
0
Add to Collection
Description
I recently started using PIR sensors with my raspberry pi to automate some lights at home! I searched for some PIR brackets but couldn't find any that were usable for my case.
These brackets are simple, no fitting required for the sensor unless you specifically wish to secure the sensor. For me, the push fitment was enough to keep my sensor stationary.
One bracket is a right andle and one is slightly angled to allow for pointing down if mounted high in a room.
There a 5mm cable guide at the back of the bracket for extra tidiness!
Printing Details
Printed at .2 layer height with 40% infill. They take about 1 hour to print with no need for supports if printed on their side.
Technical Information
| Date published | 16/02/2018 |
| Benoetigte Zeit | - 60 Minuten |
| Menge an Filament | 10 grams |
| Dimensionen | 50x48x38 |
| Technologie | FDM |
| Schwierigkeitsgrad | Easy |
| Support Free | YES |
More Information
Object Parts