Sparkler Holder
Sparkler Holder
3D
Published 2017-06-21T11:02:54+00:00
A simple and effective way to use Sparklers and create your own Mini Fireworks Display...
Designed at the request of another Thingiverse member (for use during 4th of July Celebrations) this Sparkler Holder will hold up to 27 Sparklers over three levels, with each level on a different angle, plus a centre Sparkler in the top. This lets you insert a full packet all at one time then light them sequentially / progressively or all at once (if you have an effective way of lighting lot's of Sparklers quickly).
The design features an internal retainer to locate the Sparklers so they stay at a similar angle as others on the same level as well as keeping the hot / burning part well clear of the holder itself so it won't melt or burn. The length of the Sparklers wire holder end entering the sparkler Holder is a maximum of approx. 45mm.
This is an easy print 75mm in diameter and 100mm tall that's hollow up the centre (apart from the retainer) so doesn't use a lot of filament... print one and reuse it lots of times in years to come.
Please refer to the instructions and images for additional information and please post images of your Sparkler Holder/s in use for other members to see.
Note: If you like this check out the rest of my practical and fun designs.
Just insert your Sparklers...
Make sure you insert your Sparklers so they align above the designed in retainer plate / disk. This will keep the Sparklers in position and at a similar angle as all other Sparklers inserted on the same level.
| Date published | 21/06/2017 |
| Technologie | FDM |
| Schwierigkeitsgrad | Easy |
