switch panel DLC for SMARS modular robot
switch panel DLC for SMARS modular robot
3D
Published 2019-08-05T18:00:10+00:00 • Remixed from SMARS modular robot
This remixed part of the SMARS modular robot adds a switch to your robot. You can use the switch to turn your robot on and off, since the SMARS doesnt have such a switch built in by default, or you can use it for whatever you like.
I remixed the part so it fits in the original design of the smars. It's partly education-friendly since you have to solder the components together. But once you assembled this DLC you can use it with ease, thanks to the screw terminals.
Parts list:
1x On-On / On-Off switch AMAZON
1x Screw terminal AMAZON
2x 3cm Wire AMAZON
Assembly:
The assembly is pretty straight-forward. All you have to do is mounting the switch in the hole and solder the wires onto the switch and the screw terminal. After that you can glue the screw terminal on the side of the panel.
If you want to, you can use shrink tubing to protect the circuit from shorts.
That's it!
I printed this model with .1mm layer height in around 30 minutes. Your results may vary, altough this is an very easy model to print.
| Date published | 05/08/2019 |
| Benoetigte Zeit | 30 - 31 Minuten |
| Menge an Filament | around 3-4 grams |
| Dimensionen | 46.2 x 6.5 x 10.5 mm |
| Support Free | YES |
