Wall Mount for a No. 62 Low Angle Jack Plane
Wall Mount for a No. 62 Low Angle Jack Plane
3D
Published 2018-01-30T19:00:19+00:00
This is a set of a top and bottom (toe and heel) holders to secure a No. 62 Low-Angle Jack Plane (specifically the Woodriver brand) to a tool wall. This may also work with other similar planes.
Screw holes are 5mm in diameter with a 9mm wide countersink. It fits a #8 1" screw without contacting the sole of the plane. Modify as desired, of course.
I printed this using a Prusa i3 MK3 with PrusaControl and the default PLA FAST settings. My print came out fine on the first attempt.
There's a draft on the lip that secures the top of the plane that should enable it to be printed without supports on most printers. If you're not sure, I would recommend testing by printing just the toe piece set it below the print bed by 50% (i.e., only print the top half of the model).
| Date published | 30/01/2018 |
| Benoetigte Zeit | 3 - 10 Minuten |
| Menge an Filament | 53 grams |
| Technologie | FDM |
| Schwierigkeitsgrad | Easy |
| Support Free | YES |