ArcLight3d's Print of Undead Skeleton Swordsmen - Tabletop Miniature
Community Print 3D Print of Undead Skeleton Swordsmen - Tabletop Miniature
Published 2020-01-06T06:31:47+00:00
14
1
Printed on: Tevo Delta
Material: ABS
Description
Printed with Inland ABS, @ 500% Scale .1618 layer height. Raft and supports needed, pay special attention to the bow and arrow when removing supports. Also the feet are not flat so you will need to either print a base or chop off the feet to make them level, but he could still end up top heavy. This is the skeleton model only, I just used a failed base I had laying around to stick him on to show the print. Used Citadel Acrylic paints. NOTE: If using Simplify3d you must use seperate connected surfaces to print this correctly.