maximehemion's Print of Hero Wizard (2 Versions)
Community Print 3D Print of Hero Wizard (2 Versions)
Published 2024-03-02T12:38:37+00:00
1
1
Printed on: Anycubic Photon Mono X 6K
Material: Resin
Description
Poor Li Ming, out of the batch this one had the most issues.
First the crown broke, I don't know exactly when, but the thin part of each spike was just too fragile and did not manipulate it with enought precaution
Then the face was very clogged by primer, and I don't like my fix as much as the DH (I probably should have used IPA to clean it & start over )
On a sidenote I tried to make pink gemstones with ... moderate success.