8.5mm Brushed Motor Test Stand
5,618
visitas
197
descargas
1
colección
0 comentarios
Cargando comentarios...
8.5mm Brushed Motor Test Stand
3D
Published 2016-12-22T11:18:57+00:00
19
0
Add to Collection
Descripción
I designed this motor test stand for 8.5mm micro motors so I could determine which motor and propeller combo was best. This is an easy print as long as you use supports to hold up the slot that clamps on to the motor. I used an M3 screw to clamp the motor in place and a second M3 screw so that you can adjust the level of the arm on the scale. I hope these models are helpful to you! Cheers!
**The Motor Arm does require a very small section of support inbetween the gap for the motor clamp.**
Información técnica
Date published | 22/12/2016 |
Tecnología | FDM |
Más información
Archivos