Control Horn – Elevator
$1.30 Control Horn – Elevator
3D
Published 2019-10-02T19:20:16+00:00
A 3D printable elevator control horn for mid-size model aircrafts constructed from foamboard, cardboard and/or balsa, with a wingspan of approximately 1 to 1.5 meters (~ 39 to 60 inches).
The control horn has a large lateral mounting base to provide positive control authority with minimum flex and/or flutter of the control surface. It works well with many RC aircrafts for higher speed and 3D aerobatics.
It can be easily 3D printed, without any support, on a modern inexpensive 3D Printer with a variety of materials, including PLA, PETG, ABS and many other types of printable materials.
If you wish to have the opposite orientation of the base, the object can be mirrored along “Y” axis in your slicing software prior to printing.
PLA works well for this application, unless the model aircraft will be kept or stored in a high temperature environment such as a parked car in the summer, where the temperature may exceed ~55 C (~ 130 F). At such temperature, PLA will likely deform and warp. Therefore, I strongly recommend using PETG or ABS instead, to print part.
I have successfully used this horn on my models since early 2018. It is a good upgrade for many foamboard kits.
Recommended print settings with a .4 mm nozzle:
- Layer Hight: .150 ~.160 mm, depending on motors and gearing
- 2 perimeters or shells (~0.9 mm)
- 6 bottom layers (~0.9 mm)
- 6 top layers (~0.9 mm)
- Infill 15%~20%, depending on infill type
Assembly Instructions
I recommend using medium CA, with or without accelerator, to glue the part to the model. However, feel free to use any other suitable adhesives you are comfortable with.
The holes in the control horn may be slightly undersized for your pushrods and/or clevis. For a precise fit, ream/drill them out to the correct size for your hardware.
| Date published | 02/10/2019 |
| Precio | $1.30 |
| ¿Cuándo tiempo lleva? | 18 - 30 minutos |
| Cantidad de filamento | 2.7 grams |
| Dimensiones | 26.8mm X 49.5mm X 19.5mm |
| Sin apoyo | YES |