Display Turntable
Display Turntable
3D
Published 2019-08-27T16:41:27+00:00
This is a powered turntable that can be used to display a small object/model or to take video footage, resulting in a 360° view of the object. In addition to the printed parts, I used the following equipment:-
Stepper motor and drive board
Arduino pro mini
Buck converter
Mini toggle switches
10KΩ linear potentiometer
10KΩ Resistor
Panel mount DC jack
AC to DC power supply
608ZZ bearing
Small self tapping screws
I also used a small section of prototyping stripboard to make all the connections for the components.
This webpage provided the information about how to create the code to control the stepper motor speed. With a bit of tweaking, I added the code for the direction change switch to reverse the motor.
The wiring schematic and code for the Arduino are in the "Documents Attached" section below.
Items need to be placed in the centre of the turntable otherwise there may be some wobble on the top section.
Printer: Ender 3
Resolution: 0.20 mm
Speed 50mm/s
Material: PLA
Nozzle Temp: 205°, 210° on the first layer
Bed Temp: 55°
Infill: 10%
Walls: 3
Top Layers: 4
Bottom Layers: 3
All parts were printed in PLA and are straight forward prints with no supports. However, for the top sheet, in order to obtain a smooth polished finish, you will need to print onto a glass bed. I used supports on this part to bridge the gaps between the hexagons but this may not be necessary.
Make sure seam position is set to "aligned" or "rear" [Prusaslicer] when printing the base. Do not use the "nearest" option (as I did), ugly lines will appear around the base.
| Date published | 27/08/2019 |
| ¿Cuándo tiempo lleva? | 930 - minutos |
| Cantidad de filamento | 51 metres or 152 grams |