Emperical Probe Droid
Emperical Probe Droid
3D
Published 2017-12-04T12:04:28+00:00
This is my version of the Emperical Probe Droid from the 5th movie. Mostly screen accurate. Best results at ABOUT 120% scale on FDM.
Printing the Model:
Print 3 sets of the LongLeg 1,2 &3
Print 2 sets of the ShortLeg 1 & 2
Print 5 of the claws of any mix and match between the 3 styles
Print one head of your choice.
Print one body top and one body bottom
Print display post with higher infill
Print the base - Ice Hoth
Assembly:
Glue the body top to body bottom. You can align it to the full body or anyway you like.
Glue the head parts together.
For the legs, glue the upper and lower and the claw. Position them the way you like and then glue to the bottom body
Use the peg to hold the head to the body. This allows the head to spin on the body. You know for that critical missed shot against a big hairy monkey and that bag of mostly salty water named Nan.
Glue the display post to the display stand
For the long range comm antennas, I did not include them. You should take a piece of filament and heat it up and stretch it out. Cut 2 equal length pieces and glue on the antenna nubs. There's no point in trying to print these since it can't be done.
| Date published | 04/12/2017 |
| ¿Cuándo tiempo lleva? | 1200 - minutos |
| Dimensiones | 15x80x80 |
| Tecnología | FDM |
| Complejidad | Medio |
Really nice job. I just printed and put together, no paint (yet). Thanks