Flexi Wallets
6,180
visitas
396
descargas
8
colecciones
0 comentarios
Cargando comentarios... 
Flexi Wallets
3D
Published 2017-11-13T11:12:29+00:00
47
0
Add to Collection
Descripción
This object was entered in the MakeShaper Design Challenge (see all entries here).
To demonstrate the flexibility of the material that better than a wallet, there are three different pattern designs for you to choose the one you like the most.
enjoy !!!
Información técnica
| Date published | 13/11/2017 |
Más información
Archivos
Almost perfect, overall I'm extremely satisfied with the print and design, it does have a hard thick square layer on bottom that annoys me, I believe this may be due to my slicer settings. I may try adjusting some settings since I believe my default set to 3 bottoms layers. I used 0% infil and 1 wall count with some generic tpu. I think it may be slightly better if the wallet was slimmed down to only have perimeters(no infil space) and then print it with a 2 wall count to increase strength. The 2nd card pocket also goes to the bottom of the wallet which could be annoying when in use, a wall could probably be added to allow for a bottom to be made in the pocket.