Make It RC MS01 Lower Control Arm Support and Strut Tower Parts
Make It RC MS01 Lower Control Arm Support and Strut Tower Parts
3D
Published 2018-10-25T17:12:13+00:00
FFF printable MS01 front suspension and steering assembly replacement parts.
Easy to print lower control arm support which keeps the lower control arms from dropping too low on an MS01 front suspension and steering assembly. Currently there are two options, a 1.5mm thick version and a 2mm thick version.
Easy to print upper and lower strut tower pieces. Be sure to note orientation when building.
MS01 assemblies can be ordered here:
Kit: https://shop.makeitrc.com/collections/compatible-with-the-ffr-sc1-chassis/products/make-it-rc-ms01-ep-modular-front-suspension-and-steering-assembly-base-kit
Fully assembled: https://shop.makeitrc.com/collections/compatible-with-the-ffr-sc1-chassis/products/make-it-rc-ms01-ep-modular-front-suspension-and-steering-assembly-assembled
MS01 Instructions: https://shop.makeitrc.com/pages/ms01-assembly-instructions
Print Settings
Rafts:
No
Supports:
No
Infill:
Solid
Notes:
A small size nozzle is highly recommended. Dimensional accuracy of the parts is important.
Post-Printing
For the strut tower pieces, its recommended to bore the holes to insure the rods and screws will fit. Drill the larger holes to 2mm and the smaller holes to 1.2mm.
| Date published | 25/10/2018 |
| Sin apoyo | YES |