Paul's Garage Mini Sand Rammer casting pattern
5,304
visitas
566
descargas
2
colecciones
2 comentarios
Cargando comentarios...
Paul's Garage Mini Sand Rammer casting pattern
3D
Published 2019-07-02T17:15:10+00:00
13
2
Add to Collection
Descripción
Here is a pattern I used to cast a sand rammer. This file is only one side, with 1/4" holes underneath. Print 2 of them, use the pin holes to center them in the flask during sand ramming, and enjoy your new sand rammer!
This pattern has a few degrees of draft, but I had a little trouble removing from the mold. Perhaps it needs a little more draft, but the casting did turn out ok.
I printed it with .10mm layers, 10% infill. The nicer you print the pattern, the less "processing" it will require to get a good pattern. Remember, your casting is only as good as your pattern.
Información técnica
Date published | 02/07/2019 |
Sin apoyo | YES |
Más información
Archivos
This will be metal shortly. Thanks Paul looks good.