Rolling Pin / Nudelholz
2,373
visitas
268
descargas
3
colecciones
0 comentarios
Cargando comentarios...
Rolling Pin / Nudelholz
3D
Published 2018-11-22T14:12:10+00:00
17
0
Add to Collection
Descripción
What should I say about a rolling pin? It's a rolling pin.
It is more of a toy because it is a little smaller but could be used in the kitchen as well.
Support is only needed for the bar. The handles can be printed without support since the bridge of the hole isn't big. Depending on your use case you should select a higher infill percentage.
Print all parts as provided and assemble it. It should be a tight fit. If not, just add some glue for the handles and you are ready to go.
Upload a make if you print it!
Tip me if you like it!
Información técnica
Date published | 22/11/2018 |
Más información
Archivos