Simple Knife Design
3,504
visitas
61
descargas
1
colección
0 comentarios
Cargando comentarios...
Simple Knife Design
3D
Published 2015-04-14T21:26:00+00:00
10
0
Add to Collection
Descripción
This project started as a speed excersize but later modified to be 3d printable. Glue or adhesive will be required to glue the two back pieces and center piece together after attatching the blade. I was unable to apply either an omega clip or a locking mechanism to keep the blade locked. The knife comes in a few parts and should already be sized appropriately; blade, center piece, back piece 01 and back piece 02. Tested in Cura with no supports if printed flat sides down.
Detalles de impresión
Print at 0.2 mm layer height, with 10% infill. This uses 4 g of filament and takes 1 hour and 11 minutes.
Información técnica
Date published | 14/04/2015 |
¿Cuándo tiempo lleva? | 71 - 81 minutos |
Cantidad de filamento | 4 g |
Dimensiones | multiple parts |
Complejidad | Fácil |
Más información
Archivos