--PASS/NO PASS-- PASS, prints OK --support-- Every part needed a bit support material (see image slicer/printbed) --Files-- Print is 1 STL files. Too small! Scaled up by 250 % No gapps/faults in file (checked with meshmixer/nettfab) Made 2 plane cuts to print with less support (see image slicer/printbed) Could be printed in batch (with 200x200 bed) --Printing-- 150 micron layer height printed with 2 perimeters 17% Infill (Tringular) 3 top/bottom layers --Fillament-- White PLA 220 degrees Heated bed 60 degrees --Prints-- 3 hour print job 15 gram --Post printing-- pry away support Sanding glueing