YARB for LCD
YARB for LCD
Published 2018-01-23T16:32:15+00:00
YARB for RAMPS Gadgets3D LCD and Shield v1.0 mounted onto a RAMPS board. There are legs and a nice two piece slide mount which comes from: http://www.thingiverse.com/thing:9799
I think you will like the included attachment slides. I include them here so that you do not have to search for them - BUT - if you print them please visit the originators published post and leave a comment and picture. Thanks!!! [ http://www.thingiverse.com/thing:9799 ]
EDIT: 1/13/2015 - Ooopps! I did not make this for a Geeetech LCD as I originally published but, the Gadgets3d LCD (RAMPS GADGETS3D LCD and SHIELD v1.0). However, this should work for the Geeetech too (?).
Print the component stl's you need.
The LCD cables fit through the slot in the bottom of the box.
There is the: box, top, slides X2, and Legs. The legs can be used single or print a pair for four legs. My use for the legs was to mount the box on the side of my printer and using one set of two legs supporting the other portion of the box. This should be evident in the included photos now you know how I attach the box. ;-)
These parts are for a lengthened version of the YARB. This version has wings to allow the use of a LCD monitor card attached to a RAMPS board. The cover for the box has two small extensions which print separately and are easily trimmed with a knife and glued to the cover. These small extensions cover the wing slots for the LCD. I've also included legs which lift up the box approximately 25.4mm. My YARB is attached to the side of my printer with a slide attachment and one set of legs. You possibly could print two pairs of legs for the box. I simply 'Hot Glued' the legs to the bottom of the box. Orientation, position and placement are not critical.
I hope this works for you...
EDIT: 1/13/2015
LCD @: https://gadgets3d.com/index.php?route=product/product&product_id=65
Date published | 23/01/2018 |