Z Endstop Fine Adjustment Prusa i3 - Anet A8
12,174
visitas
1,078
descargas
12
colecciones
1 comentarios
Cargando comentarios... 
Z Endstop Fine Adjustment Prusa i3 - Anet A8
3D
Published 2017-02-20T10:26:48+00:00
156
1
Add to Collection
Descripción
An adapted design of flyingferret's :
http://www.thingiverse.com/thing:1479176
This thing allows for real quick and precise adjustment of the Z limit switch.
The Leg screws into the X stepper through the X carriage and the slotted holes provide for larger adjustment where an M3 bolt/screw then allows for fine adjustment.
I used a thread tap to cut straight into the plastic, i'm sure a normal screw would cut its own thread in there easy enough if you apply enough force. Same applies to the little foot that screws onto the tip of the M3 bolt. The limit switch screws onto the switch mount with 2x M2 screws (which came with my printer)
Good luck!
Información técnica
| Date published | 20/02/2017 |
| Tecnología | FDM |
| Complejidad | Medio |
| Sin apoyo | YES |
Más información
Archivos
Okay, I'm not using this as intended but it was the perfect size for my y-axis limit switch. Thanks for sharing this design! I'm still working on my z-axis set-up.