wasabi317's Print of Light Me Up Lamp
Community Print Impresión 3D de Light Me Up Lamp
Published 2020-08-06T15:49:05+00:00
0
4
Impreso con: Creality Ender 3
Material: PLA
Descripción
This was a really nice print and it comes out very smooth, so there’s not a lot of sanding required post-print. However, I would suggest trying to print without the ring because some light connections are not able to fit. Mine was slightly larger than the ring and I ended up hot gluing the fixture. Additionally, possibly including a cut out at the bottom for the wire to go through, otherwise the model cannot stand or balance on its own.