I have been in residential, commercial, and mechanical design on AutoCAD since 1989. My 1st 3D design in autoCAD was in 1992. Since then I have done hundreds of 3D designs, mostly for buildings I was designing parts or all of. A few years back I started designing costume pieces for my friends. All my pieces were designed on AutoCAD but built by hand from leather, wood, metal or any other material I needed, or could use. Now that I own a 3D printer I am adjusting (in some cases more than adjusting) the drawings to make them 3D printable and will put them up as I finish each. Most of the drawings were top, sides, bottom and front, not in 3D so will take longer to get ready to share. most of what I will place here 1st is items that I originally drew in 3D or need very little work to adjust into 3D.