Pegboard screwdriver insert
3,450
views
135
downloads
1
collection
Community Prints
Add your picture
Soyez le premier à partager une photo de l'impression de cet objet
0 comments
Loading comments...
Pegboard screwdriver insert
3D
Published 2017-02-27T10:43:13+00:00
15
0
Add to Collection
Description
I made this insert out of frustration after the only screwdrivers I had would fall right through the rings on pegboard screwdriver holders and get stuck. These inserts hold either 1 screwdriver in the middle, or two smaller ones side by side in the same ring. The small holes have a diameter of 0.2 inches, and the large center hole has a 0.32 inch diameter. The inserts fir into standard circular pegboard screwdriver holders with ~3/4" rings. A small bump on the bottom holds the insert in place so it doesn't pull out.
https://www.youtube.com/watch?v=7LoXfJKE7hg
Technical Information
Date de publication | 27/02/2017 |
Durée d’impression | - 25 minutes |
Technologie | FDM |
Complexité | Medium |
More Information
Object Parts