Sitting, Smiling, Baby Groot (Smoothed, solidified, reinforced)
Sitting, Smiling, Baby Groot (Smoothed, solidified, reinforced)
Published 2019-07-18T08:00:10+00:00
This is a remix of a thingiverse model, link to my Thingiverse upload to view more and to see the original model.
The connection of the head and body was not a complete mesh and left holes along the side and a giant down the middle of the neck. I connected these meshes and smoothed the connection a bit for a nicer surface finish. The model has been solidified so that the hole present in the neck is now gone and will be printed with your infill settings. Everything has been smoothed out and the file size is a comfy 10% of what it used to be. When I manage time later, I will further the smoothing of the neck/body connection, but don't wait up for it as it may be a while, or never! Thanks.
TL;DR Merged the head and body mesh, removed the hole in the neck by making the model solid, smoothed the connection point, reduced file size from 212mb to 23mb. Woohoo size savings! (Also slices and loads faster!)
Print Settings
I recommend a 0.16 or lower layer height for maximum detail.
I printed the hands with a 1mm brim as they seem to lift off when printing low temperature wood PLA. If you manage great adhesion with the hands, by all means use none! Happy Printing!
Date de publication | 18/07/2019 |
Sans support | YES |
I like it! I will try with wood pla un the future.