Polytech's Print of The Four Parts of the World Holding the Celestial Sphere
Scan The World
366
views
1 comments
Loading comments... 
Community Print Impression 3D de The Four Parts of the World Holding the Celestial Sphere
Published 2022-01-24T04:55:04+00:00
1
1
Printed on: Anycubic Photon
Material: Resin
Description
This was printed 150mm tall in SHINE SING Printing Tough Resin on all default supports settings of Anycubic's Photon Workshop slicer
The resin ended up being quite brittle, so I did not remove some of the support in hard to reach areas so as to not break small parts. Not sure if photos do it justice, but it came out very nicely. Great job, Scan The World Team, as always! Thank you very much for the model.