Death Mountain Dice Tower
Death Mountain Dice Tower
3D
Published 2019-05-30T15:40:12+00:00 • Remixed from Death Mountain - Zelda Ocarina of Time
Scaled to fit a Prusa Mk3 but scales up well. I made it proportionally 2x taller to keep the "dice tower" function working as well. Scaling down not recommended unless you want to get the dice stuck inside it.
Credit to MiniWorld for the original model. Requires a bit of support, I set my overhang angle to 5 degrees in Slic3r PE and it turned out well. It was easy to remove with needle nose pliers and any scarring is internal and not visible.
So I don't get a cease and decist:
The Legend of Zelda is a video game franchise by Nintendo. The Legend of Zelda Characters, Names And Related Indicia Are Trademarks Of And © 1986 – 2019 Nintendo. Nintendo properties are trademarks of Nintendo. This model is a non-profit, fan work modeled from scratch based on the resemblance of the real game location. No trademark infringement is intended.
2+ perimeters
3+ top and bottom layers
5%+ infill
Support everywhere with a 5 degree overhang limit
| Date published | 30/05/2019 |
