Handtag-marker
Handtag-marker
3D
Published 2018-09-24T17:06:22+00:00
This is a template-form that I made to make perfekt markings where to drill holes and put handles on my IKEA kitchen drawers. (in my case "ENERYDA", with 64mm between the holes)
- You have to measure the middle of the drawer.
- Make a mark with a erasable pencil.
- "Hang" the template on the edge and slide it until the marking is in the top of the triangle. (that means that you are in the centre).
- Make markings through the two holes further down on the template.
As an IKEA expert would notice - this is just ONE measurement for one type of handle. But you can make it with multiple holes and measures - depending on how high you want the handle to sit.
Sure, took a while to print. But having exaxt markings on the 16 drawers within a minute was excellent! And if it was pre-fabricated and sold for a minor cost at IKEA - I think many would appreciate the help to get perfect measurement for drilling holes for their drawers (or any other applicable furniture).
Just lay it flat on the printbed as attached picture shows
| Date published | 24/09/2018 |
| Tempo per farlo | 80 - 85 Minuti |
| Quantità di filamento | 20 |
| Dimensioni | 80x80x10 |
| Tecnologia | FDM |
| Complessità | Easy |
| Supporto Gratuito | YES |
