ehegenberger's Print of Cat Treat Ball Dispenser
Community Print 3D Print of Cat Treat Ball Dispenser
Published 2023-01-11T10:07:59+00:00
1
0
Printed on: Prusa mk3s
Material: PLA
Description
This printed really well on the first try with no supports, just a few bits of spaghetti (shown here) that I could remove with a fingernail. Printed in PLA on a Prusa 3S+ at 0.2 mm with 15% infill. The hole is a good size to release the occasional treat without them pouring out. No problem with the threads. Nice simple design.