HDD Pi Case V1
HDD Pi Case V1
3D
Published 2018-07-30T16:54:19+00:00
Get the Full write up on my blog.
This Raspberry Pi case is designed to fit into a standard 3.5in hard drive slot. It works well with tool less mounting systems, but I also added the ability for threaded nuts to be dropped in which work great as well and make this compatible with anything that a standard hard drive fit into.
The nuts that I built around are the [McMaster-Carr 90480a007](https://www.mcmaster.com/#90480a007/) This cost me $8.32 for 100 nuts delivered to my door but I am sure a local hardware store would have the same thing far cheaper.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.40 mm
Infill:
15%
Notes:
I have printed this part a few times and you can get away with doing no supports you just end up with some long bridges. I would advise against supports inside where the nuts go because it is nearly impossible to get those supports out correctly.
| Date published | 30/07/2018 |
| Time to do | 2 - 3 minutes |
| Support Free | YES |
