MyMiniFactory Contest Theme 3: Furniture (multi surface cup holder)
MyMiniFactory Contest Theme 3: Furniture (multi surface cup holder)
3D
Published 2017-08-14T09:41:03+00:00
This object was made in Tinkercad. https://www.tinkercad.com/things/kPLvI8NwsVD
This project is a submission for the 7/16/17 tinkercad & myminifactory designing competition. This project falls under the theme 3 category “furniture.”
As a maker I try to find problems and solve them. This project might not directly be a piece of furniture but it is an accessory for furniture.
This is a practical cup holder designed to clamp onto almost any surface to prevent spills. I can’t count the number of paper documents I have ruined with my morning coffee and clumsiness. I constantly am knocking my cup over with my elbow. This design will prevent any future spills. It latches onto my desk and other surfaces. It holds my cup of coffee, soda, water, etc… so that if I bump it, it does not spill. It also keeps it a safe distance from my valuables on the table, so if I really hit it hard it will only spill on the floor.
Print parts as oriented in individual STL files. The cup holder itself requires support; the pins may required a brim to stabilize them during printing. The large jaws (in the "sides" files are just a bit too large to print on a typical 200mm x 200mm print bed and may need to be scaled down slightly. Ensure that all parts are scaled to the same percentage.
| Date published | 14/08/2017 |
| Time to do | 1529 - 1799 minutes |
| Material Quantity | 351g |
| Dimensions | 298mm x 231mm x 10mm (assembled) |
| Technology | FDM |
| Complexity | Easy |