Skull And Rattly Bones
Skull And Rattly Bones
Published 2017-03-21T11:57:47+00:00
'Skull and Rattily Bones' is a small square section skull with intersecting X-Bones that are free to move within the skull... so they rattle!
No support is required and most well set up machines should print this with no issues. The bones should be free (as an "X") straight off the build plate.
Two versions of the 'Skull and Rattily Bones' design has been provided. One includes a key ring fitting, the other doesn't so is printed ' just for fun.
If for some reason your machine / slicing app has caused your print to come out with the bones / skull stuck together check your bridging settings, Make sure you print at 0.20mm resolution (as this file is set to bridge effectively at that thickness layer), and if necessary increase the Z-Scale by 3-5% to increase the clearances. .
Great little gifts and fun around Halloween time.
Please refer to the print settings and images for additional information.
Note: If you like these print check out the rest of my fun and practical designs. And, please post images of your prints for others to see!
Use two shells with higher than normal infill to ensure the print is adequately strong to last well as a key fob / on a key ring.
No support required. Raft is optional.
...just remove your print from the builplate and the bones shouold be free / loose rattle.
Tell us more...
Date published | 21/03/2017 |
Technology | FDM |